Sentek LMC-J-0040-1 Instrukcja Użytkownika Pobierz pdf (Strona 35)

IMJ00503 V3E.DOC Page 35 of 40 19.02.2009

7. Malfunction & Error Reports

8.1 Malfunction

Error situation Cause Action for removal

No data coming via

Profibus

Faulty Profibus configuration Check Profibus configuration

Device error (Ext.

diagnosis)

Hardware problems Reship LMC J 0050 3 for repair,

contact technical support

8.2 Errror Report Outputs via Profibus

Code Cause Action for removal

E15 Excessively poor reflexes Use target board, observe minimum

requirement on

measuring distance (> 0.1 m)

E16 Excessively strong reflexes

Use target board, do mot measure against reflecting

surfaces

E17 Too much steady light (e.g. sun) Mount LMC J 0050

3 in such a position that

excessive incidence of steady light

is prevented,

extend glare protection tube, provide additional

light shielding, e.g. protective cap

E18

Only in DX mode: too much

difference between measured

and pre calculated value

Check path from distance meter to target being

measured for obstacles

E23 Temperature below –10°C Provide ambient temperature > 10°C

E24 Temperature above +60°C Provide ambient temperature < +60°C

E31

Faulty EEPROM checksum,

hardware error

Service required if fault occurs repeatedly

Reship LMC J 0040 3 for repair

E51 Failure to set avalanche voltage

1. straylight

2. hardware error

1. Check target reflectance and ambient light

(steady light), make sure that neither target

not entry opening of LMC J 0040 3 is exposed to

light from reflecting surfaces, projectors

sun)

2. Service required

reship for repair

E52

Laser current too high / laser

defective

Reship LMC J 0050 3 for repair

Contact technical support

1 2 ... 30 31 32 33 34 35 36 37 38 39

Komentarze do niniejszej Instrukcji

Brak uwag

Sentek LMC-J-0040-1 Instrukcja Użytkownika Strona 35

Komentarze do niniejszej Instrukcji